HVAC in Firestone, CO: Heating Service for a Town Where Nine Homes in Ten Are This Century's
Call Us
(720) 764-0399
Serving Firestone from Boulder
Rapid Response
Heating a home in Firestone
Firestone’s housing stock is almost entirely this century’s: 88.3 percent of its homes were built in 2000 or later, and more than half in the 2000s alone. Heating here is mostly first furnaces reaching the age at which a builder’s choices come due. Add a Town that names furnaces, boilers and water heaters on its permit notice, a set of adopted codes that is still the 2018 editions with the 2023 electrical code, and a Weld County address outside Boulder County’s rebate programme, and heating here has its own first questions. Boulder HVAC Pros heads to Firestone from Boulder. This page is about heating a home here, at 4,970 feet, and what to do when yours stops.
It is a Weld County town of about 6,090 housing units at roughly 4,970 feet, where four homes in five heat with utility gas and the median house dates from 2007. Below are four short sections, on elevation, the age of the housing, fuel and the utility question, which together frame any heating job here.
Elevation: what 4,970 feet does to a furnace
At about 4,970 feet, the U.S. Geological Survey’s figure for its centre, Firestone is the lowest of the towns we serve. Altitude requirements belong to each manufacturer and each model. Goodman’s installation manual for one gas furnace line requires a high-altitude orifice kit where the specification sheet calls for one, while its table lists no kit for natural gas up to 7,000 feet. So the question is what this furnace’s own manual requires at 4,970 feet, and whether it was followed. The manual adds a prohibition that holds everywhere: never derate by turning manifold pressure down, because thin air and low pressure “may cause incomplete combustion, flashback, and possible yellow tipping.” Incomplete combustion is how carbon monoxide forms, which is why the installation record matters as much at the bottom of our range as at the top.
Housing age: a 2007 median, half the town from one decade
The Census Bureau’s 2019–2023 American Community Survey puts the median year built for Firestone’s 6,094 housing units at 2007, with a margin of error of two years. The shape is one era: 3,134 units from 2000 to 2009, more than half the town, then 1,894 from the 2010s and 353 in 2020 or later, so 88.3 percent of the stock was built in 2000 or later. Only 5.0 percent, about 300 units, predates 1980. For a 2000s build here we start by confirming whether the furnace, ducts and sizing are original; the 3,134 homes from that decade are now between fifteen and twenty-five years old. The heating question in a town like this is whether the first replacement corrects what the builder installed, or simply repeats it. Read the shape rather than the count.
Your next step
If your furnace is struggling, ring Boulder HVAC Pros on (720) 764-0399. Before you do, find the rating plate, your electric and gas bills, whose names settle the rebate question, and the build year.
HVAC services in Firestone
With nearly nine in ten Firestone homes built in 2000 or later, the list below leans toward the questions a younger house raises, then cooling and hot water. Each item names the page with the detail. Firestone’s neighbours on our list are indexed on the service-area page for all fourteen towns.
Furnace repair. On a 2000s house still on its original furnace, the components to check are a sensor, an igniter, an inducer or a pressure switch, and behind them a measurement of duct static pressure against the furnace’s rated range. We open with the manual’s instructions for this elevation. Next: furnace repair for Firestone houses.
Furnace replacement. A replacement is the chance to correct what the builder sized: a load calculation rather than a like-for-like swap, and whatever the furnace’s manual requires at this elevation. The Town’s Building Safety Month notice lists “installing appliances and replacements such as furnaces, boilers, water heaters, fireplaces and space heaters” among the projects that require a permit, permits run through the Town’s online portal, its building guides include a gas load form, and the codes it inspects against are the 2018 International Mechanical and Fuel Gas Codes under Ordinance 1029. Confirm the permit with the Building Division before work starts. See furnace installation.
Heat pumps. With one in seven homes here already heating with electricity, a cold-climate heat pump is a live option, with a gas furnace kept as backup where there is one. The rebate question turns on which utilities serve the address, so it is one for the names on your bills. Read installing a heat pump and heat pump repair.
Maintenance. An annual inspection is the one service that pays for itself on a fifteen-year-old original: combustion check, static pressure, flue condition. See heating maintenance and tune-ups.
Water heaters and boilers. Both are on the Town’s permit notice. See water heater services and boiler upkeep and repair.
Air conditioning. For cooling: AC installation and AC repair.
When it will not wait. No heat in a full house on a January night means emergency HVAC repair, not a wait.
Why homeowners in Firestone call Boulder HVAC Pros
- Our base is Boulder, west of Firestone across the county line.
- We know that a furnace here has to be set up for 4,970 feet, and the first thing we check on every gas appliance here is what its own manual requires at this elevation.
- We know that Firestone is a Weld County town, so we do not promise a Boulder County rebate here, and we ask whose names are on the bills before we say anything about a utility rebate.
- And we know the Town's process: a contractor licence from the Town, issued for the calendar year and renewed annually, with heating and air conditioning listed under its Class B, a certificate of insurance naming the Town, a permit for a furnace, boiler or water heater through the online portal, and inspections to the 2018 codes with the 2023 National Electrical Code.
Why this winter, in Firestone
- anyone expecting a federal credit on a 2026 furnace or heat pump will be disappointed: 25C applied only to efficient equipment placed in service before December 31, 2025. Our rebates guide has the current picture.
- the codes. The Town's Building Permits page lists the 2018 editions of the International Residential, Mechanical, Fuel Gas, Existing Building and Energy Conservation Codes with the 2023 National Electrical Code, adopted under Ordinance 1029. Mead, Frederick and Dacono list the 2024 editions on their own pages; Firestone's page still lists 2018, so a contractor working across the county line should expect to be inspected against a different edition here, and a homeowner should ask which one the permit was issued under.
- from January 1, 2026 any new furnace or water heater sold in Colorado must meet the state's emissions limit, so the unit that replaces an existing furnace here this winter will too. And the town's own housing profile puts the pressure on: 3,134 homes built in the 2000s are now fifteen to twenty-five years old, which is the span in which a builder-grade furnace goes from repairable to a replacement decision. A replacement planned in autumn is a load calculation and a permit; one forced in January is whatever can be fitted that week.
How Firestone heats: four in five on gas, one in seven on electricity
The same survey’s house-heating-fuel table records 5,877 occupied homes: 82.3 percent heat primarily with utility gas, 15.2 percent, 894 homes, with electricity, and 1.1 percent, 65 homes, with bottled, tank or LP gas; fuel oil and wood each account for 28 homes. Three things to keep in mind about the table. It files every household under one main fuel, so a heat pump with a furnace behind it counts once; the data span 2019 to 2023; and the electric count cannot distinguish a heat pump from baseboard. The shape is a gas town with a sizeable electric share, and a heating call here starts with which fuel, because a propane furnace needs its manufacturer’s LP conversion kit as well as whatever its manual requires at this elevation.
Who serves this address: Weld County, and a question for your bill
The Census Bureau’s 2020 place-by-county file lists the Town of Firestone under Weld County. That matters for one rebate in particular: Boulder County’s EnergySmart programme is for Boulder County residents, so it does not apply to an address here. This page makes no claim about which electric or gas utility serves a Firestone home; the Town’s utility pages cover its own water and billing, and name no energy provider. Eligibility for any utility rebate depends on which utility serves the address, so check the names on your electric and gas bills before assuming one applies. Where the gas is Xcel’s, its furnace rebate requires Xcel gas service and a 95 percent AFUE unit replacing a non-condensing one, and its heat pump rebates require an Xcel electric or gas account. Where it is not, ask that utility directly what it offers.
Firestone heating FAQ
Is it worth replacing a 30 year old furnace?
In Firestone that question describes about 300 homes, the 5.0 percent built before 1980, and a furnace of that age there is not the original. Age alone does not decide it; three findings do: whether what its manual requires at this elevation was done; what the flue and return it feeds look like; and whether the replacement would be sized by a load calculation rather than by copying the old unit. Any new furnace sold in Colorado from January 1, 2026 is subject to the state’s emissions limit. Ask for those findings in writing before anyone quotes a replacement.
What are signs I need HVAC repair or replacement?
We do not diagnose from a list of symptoms, so here is what is checked instead. On a gas furnace: the flame sensor, igniter, inducer and pressure switch; combustion and carbon monoxide at the flue; static pressure across the ductwork; and what the furnace’s own manual requires at this elevation. On a heat pump: refrigerant charge, defrost operation, and the balance point with any backup heat. A repair is what those checks call for; a replacement is what a load calculation and the age of the ductwork call for. If you smell gas or a carbon monoxide alarm sounds, leave the house and call the gas utility and the fire department before calling anyone else.
Do you need a permit to replace a furnace in Firestone, and which codes apply?
The Town’s Building Safety Month notice says the Town requires permits for home improvement projects including electrical, mechanical, structural or plumbing work, and lists “installing appliances and replacements such as furnaces, boilers, water heaters, fireplaces and space heaters” among the common projects that require one. It adds that the property owner is ultimately responsible for obtaining the permit, whoever pulls it. The Building Permits page lists the adopted codes: the 2018 International Building, Residential, Plumbing, Mechanical, Existing Building, Fuel Gas and Energy Conservation Codes with the 2023 National Electrical Code, under Ordinance 1029. Confirm with the Building Division before work starts.
Which utility serves Firestone, and does it affect rebates?
This page makes no claim about it. The Town’s utility pages cover its own water, trash and billing and do not name an electric or gas provider, so check the names on your bills. Eligibility for a utility rebate depends on which utility serves your address. Where it is Xcel, its furnace rebate requires Xcel gas service and a 95 percent AFUE unit replacing a non-condensing one, and its heat pump rebates require an Xcel electric or gas account. Where it is another utility, ask that utility directly.
How old are Firestone homes, and why does that matter for heating?
The 2019–2023 American Community Survey puts the median year built at 2007, with 88.3 percent of 6,094 units built in 2000 or later, 3,134 of them in the 2000s alone; 5.0 percent predate 1980. On a house built in 2000 or later, we start by confirming whether the furnace and its sizing are original, because a replacement is where a load calculation puts the sizing right or carries the error forward.
Do Firestone homes heat with gas, propane or electricity?
Mostly utility gas: 82.3 percent of 5,877 occupied homes, with 15.2 percent, 894 homes, on electricity and 1.1 percent, 65 homes, on bottled, tank or LP gas, per the same survey; fuel oil and wood each account for 28. Each house is recorded under a single fuel, with heat pumps and baseboard in one row. An all-electric home here is a candidate for a cold-climate heat pump; a propane furnace needs the manufacturer’s LP conversion kit as well as whatever its manual requires at this elevation.